LACP Port-Channel Trunk

1. Enter the configuration mode. 
 config t 
 2. Enter the interface/s that you want to add to the port channel/LACP. 
 int e1/5 
 For multiples use below. 
 int e1/5-6 
 3. Give a description of the ports. 
 desc MUT7-RACK-SWI-POE1 
 4. Configure the port/s as a switchport. 
 switchport 
 5. Configure the port/s as a trunk. 
 switchport mode trunk 
 6. Configure the port as a port-channel. Active sets the interface to LACP Active, Passive sets it to LACP Passive, and not setting a mode defaults to On . 
 channel-group 1 mode active 
 7. Enter the configuration for the port channel. 
 int port-channel 1 
 8. Give a description of the port-channel. 
 desc MUT7-RACK-SWI-POE1 
 9. Configure the port-channel as a trunk port. 
 switchport mode trunk 
 10. Issue the command no shutdown to enable the port. 
 no shutdown 
 11. Add VLANs if needed to the port-channel interface. Edit accordingly to allow only necessary VLANs. 
 switchport trunk allowed vlan add 1,2,5,20,30,49,50,60,77,79,200,243